BASIC Programming of Analog (ETP) Call Stations
What is the BASIC programming codes for the analog (ETP) devices? Resolution: What you will need: Analog telephone or test-set to dial in access to the ETP device The BASIC of QUICK programming for analog ETP devices is as follows: Default ...
What is the SIM Card Size for ETP-GSM (AT&T)
What type of SIM card does the ETP-GSM use for AT&T? ETP-GSM Answer: ETP-GSM uses the STANDARD SIM Card. SIM Card Sizes If you need additional assistance, please email us at email@example.com or call 773-539-1100 and select Technical Support.
Front status (CALLING and ANSWERED) LED's on VOIP Call Station Flashing
If the front LED's are continuously flashing on a VOIP-500/600 it means the device cannot register to a SIP server, firmware upgrade is in progress OR the device is in a constant reboot cycle due to not being able to obtain a DHCP IP address. ...
How To Configure the AVM-1 (GXV3370) and the VOIP-20X (with IP Camera) - Peer To Peer
This knowledge article describes the setup of the AVM-1 (GXV3370) and the VOIP-20X (With IP Camera) in a peer-to-peer environment: Assumptions: Technician has fundamental knowledge in computer networking and Voice over Internet Protocol (VoIP) ...
Default IP Addresses for Talkaphone Products
The default (Factory) IP Addresses are listed below for the various Talkaphone products: Resolution: VOIP-20X, VOIP-500/600: IP 192.168.1.10 SUBNET MASK 255.255.255.0 AVM-1 (Grandstream GXV3275) IP 192.168.1.200 SUBNET MASK 255.255.255.0 IP CAMERA IP ...