Analog AOR-8/16/24/32 Main Board 68324A

• Related Articles

• AOR-IP Command Unit (CU) Configuration

  This document covers the basic configuration needed for any of the AOR-IP Command units. (AOR-IP-40-CU, AOR-IP-80-CU, AOR-IP-120-CU, AOR-IP-160-CU) General Information The AOR-IP command units ship pre-configured for up to 160 call station, one ...

• AOR-IP Supervisor Configuration

  The AOR-IP-SUP comes pre-configured, for standard subnet used in the AOR-IP-SUP, but will need the proper configuration loaded and the scripts modified for the number of stations, in order to monitor the correct Network Devices. Configuration ...

• How to Set Number of Stations Connected to an AOR-5 or AOR-10 Series Master Controller

  Fault Detection Configuration for AOR-CSE Stations and PSTN Line: Carrying out this procedure on the controller board is required for proper open/short fault and PSTN/POTS telephone line fault detection on the system. In the lower-right of the ...

• AOR-IP Auxiliary Master Station

  Configuring the Auxiliary Master Station The Auxiliary Master station comes configured to support up to 160 call stations and configured to import the names of the call stations from the Command Unit. The IP address, sip credentials and number of ...

• Programming the EC-8 or AOR series, and Analog stations for Local Only

  Programming for an EC-8 or AOR Call into the unit or go off hook on the local phone, be sure and select the correct bank if working with an AOR-16, AOR-14, or AOR-32, and what for three tones. Enter *31** to access programming, wait for a single beep ...