AOR-5 or AOR-10 No power or battery light on front cover, but some trouble lights are lit for stations, and there are red LEDs lit on the PCB
The ribbon cable from the front panel to the PCB, is upside down when where it connects to the PCB. The red wire is pin 1 and should be at the top of the connector when it is correctly plugged into the PCB.
Other symptoms include:
Configure button not working
Trouble lights lit for stations 2-4 or 2-9 even if stations have good connections.
Unable to call stations
Related Articles
AOR-IP-CSE Revision 1 Call station Configuration
This article assumes that the suggested default IP scheme for the AOR-IP series is being used. The IP scheme can be found here . This article is for the first version of the AOR-IP-CSE That is based on the PCB with P/N 68820, It has two network ports ...
How to Set Number of Stations Connected to an AOR-5 or AOR-10 Series Master Controller
Fault Detection Configuration for AOR-CSE Stations and PSTN Line: Carrying out this procedure on the controller board is required for proper open/short fault and PSTN/POTS telephone line fault detection on the system. In the lower-right of the ...
AOR-IP Supervisor Configuration
The AOR-IP-SUP comes pre-configured, for standard subnet used in the AOR-IP-SUP, but will need the proper configuration loaded and the scripts modified for the number of stations, in order to monitor the correct Network Devices. Configuration ...
AOR-IP Command Unit (CU) Configuration
This document covers the basic configuration needed for any of the AOR-IP Command units. (AOR-IP-40-CU, AOR-IP-80-CU, AOR-IP-120-CU, AOR-IP-160-CU) General Information The AOR-IP command units ship pre-configured for up to 160 call station, one ...
AOR-IP Auxiliary Master Station
Configuring the Auxiliary Master Station The Auxiliary Master station comes configured to support up to 160 call stations and configured to import the names of the call stations from the Command Unit. The IP address, sip credentials and number of ...