Default IP Addresses for Talkaphone Products

• Related Articles

• Default IP address of the network camera in the IP Call Stations and connection information

  The IP Call Stations and the  IP camera are two separate  network  entities inside the same enclosure . Each of them need an individual power source and a dedicated network  connection to operate. Please find attached a link to the manual for the ...

• How do I factory reset a VOIP-200 Call Station?

  How do I factory reset a VOIP-200 Call Station? Answer: Reset to Factory Default Settings with Static IP 1. While pressing the call button, power up the substation. 2. When the substation LED starts blinking, release the call button after exactly 2 ...

• Configur AOR-IP-CSE Revision 2

  Download the configuration app and update from this article: AOR-IP-CSE Appilictaion download (Non Web Interface Version) 1. Launch the Talkaphone Programming software. 2. Select the device you wish to program. 3. Click the Connect button. 4. If you ...

• How to find out the IP Address acquired by the VOIP-500/VOIP-600 IP Call Stations from the DHCP server using Serial connection?

  Requirements: Serial connection to the VOIP-500 or VOIP-600 FTP server that supports receiving files via ftpput.  Filezilla will support this Power supply or POE switch Network connection to VOIP-500 or VOIP-600. Procedure: 1.  Connect a ...

• How To Install the AVM-1 and the VOIP-20X (with IP Camera) - Peer To Peer

  This knowledge article describes the setup of the AVM-1 and the VOIP-20X (With IP Camera) in a peer-to-peer environment: Assumptions: Technician has fundamental knowledge in computer networking and Voice over Internet Protocol (VoIP) technologies is ...