Does an ETP Call Station remember its programming if I unplug it?

• Related Articles

• Quick programming for the ETP-520 Series call stations

  NOTE: After each programming code, a single beep indicates the code has been accepted. A double-beep indicates an error—re-enter the code again. 1.1. Quick Programming Guide Programming the ETP-520 Series Call Station is relatively quick and easy. ...

• BASIC Programming of Analog (ETP) Call Stations

  What is the BASIC programming codes for the analog (ETP) devices? Resolution: What you will need: Analog telephone or test-set to dial in access to the ETP device The BASIC of QUICK programming for analog ETP devices is as follows: Default ...

• Programming ETP Series Phones using the local phone on a EC-8 Consolidator

  What is the BASIC programming codes for the analog (ETP) devices by using the local phone on a EC-* Consolidator? Resolution: What you will need: Analog telephone or test-set to dial in access to the ETP device When using an EC-8, connect the local ...

• I have made several mistakes in programming my ETP Call Station and/or I don't know what has been programmed into my phone. Can I start over from the factory settings?

  I have made several mistakes in programming my ETP Call Station and/or I don't know what has been programmed into my phone. Can I start over from the factory settings? Answer: There is no programming code that resets you phone to factory settings. ...

• ETP-400, ETP-500, ETP-100, ETP-110, Microphone not working on outbound call on autodial, ringdown, hotline or PLAR

  For the ETP-520see this article, ETP-520 Programming Example for Autodial/Ringdown/PLAR Lines PLAR is another name for the ringdown/Autodial/Hotline Configure as follows Call into the station Dial *4** to access programming and, wait for a single ...