ETP-520 series with ETP-WM 120VAC Wiring Diagram
Related Articles
ETP-WM Series ADA Mounting Height Recomendations
I. ADA Height Requirements In order for a call station to comply with the Americans With Disabilities Act (ADA), all operable parts (i.e. pushbuttons and keypad) must be no higher than 48.00” above the finished floor from a forward reach or 54.00” ...ETP-WM Wiring Diagram With ETP-520 and 12/24 vdc
ETP-EL Installation Instructions
THIS PRODUCT MUST BE INSTALLED IN ACCORDANCE WITH THE APPLICABLE INSTALLATION CODE BY A PERSON FAMILIAR WITH THE CONSTRUCTION AND OPERATION OF THE PRODUCT AND THE HAZARDS INVOLVED CE PRODUIT DOIT ÊTRE INSTALLÉ SELON LE CODE D’INSTALLATION PERTINENT, ...Configuration for DataRemote CDS-9070 and ETP-500 Series Analog Call Stations
Configuration for DataRemote\MetTel CDS-9070 and ETP-500 Series Analog Call Stations Configuration Required on the DataRemote\MetTel CDS-9070 CPC: Enabled CPC Delay: 10 seconds CPC Duration: 1 second Programming the ETP-500 series device Call into ...Adjusting the Microphone/Speaker on the ETP-110 Series Analog Call Station
How do I adjust the microphone/speaker balance for the ETP-110 Series Analog Call Station? Answer: 1. Remove the ETP-110 Series Analog Call Station from it from its mounting enclosure. 2. Remove the four (4) Phillips screws marked in red below. 3. ...