Is the ETP-CI-4G-GSM compatible with Canadian Cellular Carriers

While Model ETP-CI-4G-GSM does not carry any carrier certifications in Canada, there are end users activating and utilizing this product on Tier 1 carrier networks (e.g., Rogers, Bell Canada, Telus).

• Related Articles

• Configuration for DataRemote CDS-9070 and ETP-500 Series Analog Call Stations

  Configuration for DataRemote\MetTel CDS-9070 and ETP-500 Series Analog Call Stations Configuration Required on the DataRemote\MetTel CDS-9070 CPC: Enabled CPC Delay: 10 seconds CPC Duration: 1 second Programming the ETP-500 series device Call into ...

• ETP-EL Installation Instructions

  THIS PRODUCT MUST BE INSTALLED IN ACCORDANCE WITH THE APPLICABLE INSTALLATION CODE BY A PERSON FAMILIAR WITH THE CONSTRUCTION AND OPERATION OF THE PRODUCT AND THE HAZARDS INVOLVED CE PRODUIT DOIT ÊTRE INSTALLÉ SELON LE CODE D’INSTALLATION PERTINENT, ...

• ETP-WM Series ADA Mounting Height Recomendations

  I. ADA Height Requirements In order for a call station to comply with the Americans With Disabilities Act (ADA), all operable parts (i.e. pushbuttons and keypad) must be no higher than 48.00” above the finished floor from a forward reach or 54.00” ...

• How do I change the Primary Number on an ETP-400

  Call the phone number for the line that the ETP-400 is attached to. Wait for the string of tones that is played when the ETP-400 answers the call. Enter *4** on the keypad of the phone you are calling from, and wait for a single tone in confirmation. ...

• Adjusting the Microphone/Speaker on the ETP-110 Series Analog Call Station

  How do I adjust the microphone/speaker balance for the ETP-110 Series Analog Call Station? Answer: 1. Remove the ETP-110 Series Analog Call Station from it from its mounting enclosure. 2. Remove the four (4) Phillips screws marked in red below. 3. ...