ETP-WM Wiring Diagranm with ETP-520 and 12 or 24 vdc

ETP-WM Wiring Diagram With ETP-520 and 12/24 vdc


    • Related Articles

    • ETP-520 series with ETP-WM 120VAC Wiring Diagram

    • ETP-WM Series ADA Mounting Height Recomendations

      I. ADA Height Requirements In order for a call station to comply with the Americans With Disabilities Act (ADA), all operable parts (i.e. pushbuttons and keypad) must be no higher than 48.00” above the finished floor from a forward reach or 54.00” ...

    • ETP-EL Installation Instructions

      THIS PRODUCT MUST BE INSTALLED IN ACCORDANCE WITH THE APPLICABLE INSTALLATION CODE BY A PERSON FAMILIAR WITH THE CONSTRUCTION AND OPERATION OF THE PRODUCT AND THE HAZARDS INVOLVED CE PRODUIT DOIT ÊTRE INSTALLÉ SELON LE CODE D’INSTALLATION PERTINENT, ...

    • How do I change the Primary Number on an ETP-400

      Call the phone number for the line that the ETP-400 is attached to. Wait for the string of tones that is played when the ETP-400 answers the call. Enter *4** on the keypad of the phone you are calling from, and wait for a single tone in confirmation. ...

    • Configuration for DataRemote CDS-9070 and ETP-500 Series Analog Call Stations

      Configuration for DataRemote\MetTel CDS-9070 and ETP-500 Series Analog Call Stations Configuration Required on the DataRemote\MetTel CDS-9070 CPC: Enabled CPC Delay: 10 seconds CPC Duration: 1 second Programming the ETP-500 series device Call into ...