How do I activate the Blue Light (Flash) when the button is pushed? (ETP Analog Devices)

How do I activate the Blue Light (Flash) when the button is pushed? (ETP Analog Devices)

How do I activate the Blue Light (Flash) when the button is pushed? (ETP Analog Devices)

Resolution:

Assumptions:
The ETP-EL (Blue Light) is powered and connected to the BLACK/ORANGE wires from the ETP device which is Output #2.
​

On an ETP device, you perform the following programming steps:
  1. Dial into the device
  2. Dial the programming access code (Default is: *4**)
  3. Dial *56* - Sets Button #1 to activate Output #2
  4. Dial # to disconnect from the ETP device.
  5. Test by pushing button #1

If you need additional assistance, please email us at support@talkaphone.com or call 773-539-1100 and select Technical Support.

    • Related Articles

    • ETP-EL Blue Light flashes when not in a call

      Issue: ETP-EL Blue Light flashes when not in a call Environment: ETP Towers that have a Blue Light on/in them. Resolution: Disconnect the ORANGE/BLACK from the call station, if flashing stops, possible issue with the call station. If the flashing ...

    • Quick programming for the ETP-520 Series call stations

      NOTE: After each programming code, a single beep indicates the code has been accepted. A double-beep indicates an error—re-enter the code again. 1.1. Quick Programming Guide Programming the ETP-520 Series Call Station is relatively quick and easy. ...

    • ETP-520 Programming Example for Autodial/Ringdown/PLAR Lines

      NOTE: After each programming code, a single beep indicates the code has been accepted. A double-beep indicates an error—re-enter the code again. 1.2. Accessing Programming Mode The ETP-520 Series Call Station can be programmed from a standard ...

    • BASIC Programming of Analog (ETP) Call Stations

      What is the BASIC programming codes for the analog (ETP) devices? Resolution: What you will need: Analog telephone or test-set to dial in access to the ETP device The BASIC of QUICK programming for analog ETP devices is as follows: Default ...

    • How to program single button ETP-520 on EC-6 and trigger output 2

      Call the number of the line attached to the EC-6 When the EC-6 answers it will beep once. Enter port number to reach port. Wait for the ETP-520 to finish playing its ID tone. Enter *4** to access programing, wait for single tone in confirmation . ...