How do I change the Primary Number on an ETP-400

How do I change the Primary Number on an ETP-400



  1. Call the phone number for the line that the ETP-400 is attached to. Wait for the string of tones that is played when the ETP-400 answers the call.
  2. Enter *4** on the keypad of the phone you are calling from, and wait for a single tone in confirmation. If a double tone is heard or anything else besides a single tone, enter repeat the *4** until a single tone is heard.
  3. Enter *13*New Number you want it to dial*

    • Related Articles

    • Configuration for DataRemote CDS-9070 and ETP-500 Series Analog Call Stations

      Configuration for DataRemote\MetTel CDS-9070 and ETP-500 Series Analog Call Stations Configuration Required on the DataRemote\MetTel CDS-9070 CPC: Enabled CPC Delay: 10 seconds CPC Duration: 1 second Programming the ETP-500 series device Call into ...

    • ETP-EL Installation Instructions

      THIS PRODUCT MUST BE INSTALLED IN ACCORDANCE WITH THE APPLICABLE INSTALLATION CODE BY A PERSON FAMILIAR WITH THE CONSTRUCTION AND OPERATION OF THE PRODUCT AND THE HAZARDS INVOLVED CE PRODUIT DOIT ÊTRE INSTALLÉ SELON LE CODE D’INSTALLATION PERTINENT, ...

    • Programming the EC-8 or AOR series, and Analog stations for Local Only

      Programming for an EC-8 or AOR Call into the unit or go off hook on the local phone, be sure and select the correct bank if working with an AOR-16, AOR-14, or AOR-32, and what for three tones. Enter *31** to access programming, wait for a single beep ...

    • ETP-WM Series ADA Mounting Height Recomendations

      I. ADA Height Requirements In order for a call station to comply with the Americans With Disabilities Act (ADA), all operable parts (i.e. pushbuttons and keypad) must be no higher than 48.00” above the finished floor from a forward reach or 54.00” ...

    • Adjusting the Microphone/Speaker on the ETP-110 Series Analog Call Station

      How do I adjust the microphone/speaker balance for the ETP-110 Series Analog Call Station? Answer: 1. Remove the ETP-110 Series Analog Call Station from it from its mounting enclosure. 2. Remove the four (4) Phillips screws marked in red below. 3. ...