How do I set the AVM-1 to auto dial a Call Station when I pick up the handset?
How do I set the AVM-1 to auto dial a Call Station when I pick up the handset?
Answer:
- Log into the web interface of the AVM-1
- Click the Advanced Settings tab, then click the Call Features menu item in the left hand navigation.
- About half way down the page, locate the "Offhook Auto Dial:" text box.
- Set the "Offhook Auto Dial:" section to the IP Address and port of the Call Station.
- For example:
- Save and Apply settings then test.
- Optional, you can set the Off hook Auto Dial Delay.
If you need additional assistance, please email us at support@talkaphone.com or call 773-539-1100 and select Technical Support.
Related Articles
How To Install the AVM-1 and the VOIP-20X (with IP Camera) - Peer To Peer
This knowledge article describes the setup of the AVM-1 and the VOIP-20X (With IP Camera) in a peer-to-peer environment: Assumptions: Technician has fundamental knowledge in computer networking and Voice over Internet Protocol (VoIP) technologies is ...ETP-520 Programming Example for Autodial/Ringdown/PLAR Lines
NOTE: After each programming code, a single beep indicates the code has been accepted. A double-beep indicates an error—re-enter the code again. 1.2. Accessing Programming Mode The ETP-520 Series Call Station can be programmed from a standard ...ETP-400, ETP-500, ETP-100, ETP-110, Microphone not working on outbound call on autodial, ringdown, hotline or PLAR
For the ETP-520see this article, ETP-520 Programming Example for Autodial/Ringdown/PLAR Lines PLAR is another name for the ringdown/Autodial/Hotline Configure as follows Call into the station Dial *4** to access programming and, wait for a single ...Run a Digital Output script from a call originated from an AVM-1 to the VOIP-200/VOIP-500/VOIP-600 IP Call Stations
To call into the VOIP-200/VOIP-500/VOIP-600 IP Call Stations from the AVM-1, select IP Call from the drop-down. Then put in the IP address of the IP Call Station(use * for a dot on the soft keypad on the AVM-1). The IP Call Station will auto-answer ...How to do a packet capture on the VOIP-500/VOIP-600 Series IP Call Stations using tcpdump?
1. Login to the VOIP-500/VOIP-600 Call Station console either by using a Serial cable or through SSH. 2. Navigate to the /flash directory- root:/> cd /flash 3. Run the command to start capturing packets- root:/flash> tcpdump -w call1.pcap ...