How to program single button ETP-520 on EC-6 and trigger output 2
Call the number of the line attached to the EC-6
When the EC-6 answers it will beep once.
Enter port number to reach port.
Wait for the ETP-520 to finish playing its ID tone.
Enter *4** to access programing, wait for single tone in confirmation .
Enter the primary phone number to be dialed#00 to save as primary number, wait for single tone in confirmation.
Enter 121111#76 to set activation of relay 2 with button 1 for duration of call, wait for confirmation tone.
#7 to disconnect
Related Articles
How to change the Primary phone number on an ETP-400, ETP-500, ETP-100, ETP-103, or ETP-110
You will need to know the number associated with the telephone line that the Talkaphone is connected to, and the number that the Talkaphone should call when the button is pressed. This also assume that there is not another device on the line that is ...
Quick programming for the ETP-520 Series call stations
NOTE: After each programming code, a single beep indicates the code has been accepted. A double-beep indicates an error—re-enter the code again. 1.1. Quick Programming Guide Programming the ETP-520 Series Call Station is relatively quick and easy. ...
ETP-520 Programming Example for Autodial/Ringdown/PLAR Lines
NOTE: After each programming code, a single beep indicates the code has been accepted. A double-beep indicates an error—re-enter the code again. 1.2. Accessing Programming Mode The ETP-520 Series Call Station can be programmed from a standard ...
Unable to program an ETP-400, ETP-500, or ETP-520 when connected to an ETP-CI-4G-V or ETP-CI-4G-GSM
Accessing configuration Configuration of the ETP-CI-4G-V or ETP-CI-4G-GSM is available via communications with the CONFIG USB connection. Configuration can be accomplished by connecting a terminal device (e.g. laptop or desktop computer running a ...
Programming ETP Series Phones using the local phone on a EC-8 Consolidator
What is the BASIC programming codes for the analog (ETP) devices by using the local phone on a EC-* Consolidator? Resolution: What you will need: Analog telephone or test-set to dial in access to the ETP device When using an EC-8, connect the local ...