If I have more than one consolidator can I connect them to the same phone line either in parallel or in series (using a “daisy chain”)?

• Related Articles

• Programming ETP Series Phones using the local phone on a EC-8 Consolidator

  What is the BASIC programming codes for the analog (ETP) devices by using the local phone on a EC-* Consolidator? Resolution: What you will need: Analog telephone or test-set to dial in access to the ETP device When using an EC-8, connect the local ...

• How can I have multiple Talkaphone Call Stations use a single TELCO or PBX phone line?

  How can I have multiple Talkaphone Call Stations use a single TELCO or PBX phone line? Answer: Each Talkaphone Call Station requires either a dedicated TELCO phone line or analog PBX extension. We currently offer the EC-6 Phone line consolidator. For ...

• I am using an EC-8 Consolidator in “local” mode. What should I enter as the phone number?

  I am using an EC-8 Consolidator in “local” mode.  What should I enter as the phone number? Answer: You must enter a phone number (see Primary & Secondary Phone Number Codes, p.6) even though your Talkaphone unit is not using this number to connect to ...

• Area of Rescue Command Unit Installation Guide for Model AOR-8 and Model AOR-16

  Important Notice THIS PRODUCT MUST BE INSTALLED IN ACCORDANCE WITH THE APPLICABLE INSTALLATION CODE BY A PERSON FAMILIAR WITH THE CONSTRUCTION AND OPERATION OF THE PRODUCT AND THE HAZARDS INVOLVED CE PRODUIT DOIT ÊTRE INSTALLÉ SELON LE CODE ...

• I have made several mistakes in programming my ETP Call Station and/or I don't know what has been programmed into my phone. Can I start over from the factory settings?

  I have made several mistakes in programming my ETP Call Station and/or I don't know what has been programmed into my phone. Can I start over from the factory settings? Answer: There is no programming code that resets you phone to factory settings. ...