Programming ETP Series Phones using the local phone on a EC-8 Consolidator

Programming ETP Series Phones using the local phone on a EC-8 Consolidator

What is the BASIC programming codes for the analog (ETP) devices by using the local phone on a EC-* Consolidator? 

Resolution: 

What you will need: 
  • Analog telephone or test-set to dial in access to the ETP device
  • When using an EC-8, connect the local phone to the 'Local Phone' port and verify you hear three tones.

The BASIC of QUICK programming for analog ETP devices is as follows: 
        Connect to the ETP which you need to program on port 'x' of the EC-8 using the following code on the local phone:
        Dial:  *4x* 

The ETP will auto-answer and you will be in the programming mode. Enter the following codes to program the ETP for dialing out to a number:


Default Guard/Programming Access Code:
Dial:  *4** 

Program the mode: (*14*<1/2/3>*)
Dial: *4<MODE>*
  • 1 - Central Office (Phone Company TELCO line)
  • 2 - PBX w/Consolidator
  • 3 - PBX wOUT/Consolidator
Add Phone number to be called:
Dial: *13*<PHONE#>*

Complete Programming:
Dial:  # 


If you need additional assistance, please email us at support@talkaphone.com or call 773-539-1100 and select Technical Support.

    • Related Articles

    • Quick programming for the ETP-520 Series call stations

      NOTE: After each programming code, a single beep indicates the code has been accepted. A double-beep indicates an error—re-enter the code again. 1.1. Quick Programming Guide Programming the ETP-520 Series Call Station is relatively quick and easy. ...

    • BASIC Programming of Analog (ETP) Call Stations

      What is the BASIC programming codes for the analog (ETP) devices? Resolution: What you will need: Analog telephone or test-set to dial in access to the ETP device The BASIC of QUICK programming for analog ETP devices is as follows: Default ...

    • I am using an EC-8 Consolidator in “local” mode. What should I enter as the phone number?

      I am using an EC-8 Consolidator in “local” mode.  What should I enter as the phone number? Answer: You must enter a phone number (see Primary & Secondary Phone Number Codes, p.6) even though your Talkaphone unit is not using this number to connect to ...

    • ETP-CDMA-V Troubleshooting

      Troubleshooting calls using ETP-400/ETP-500 series and ETP-CDMA-V Is the ETP-CDMA-V receiving power?  There should be several lights on the front face of the unit, that has the RJ-11 connection if the device is receiving power. If the power has been ...

    • How to change the Primary phone number on an ETP-400, ETP-500, ETP-100, ETP-103, or ETP-110

      You will need to know the number associated with the telephone line that the Talkaphone is connected to, and the number that the Talkaphone should call when the button is pressed. This also assume that there is not another device on the line that is ...