Unable to access the VOIP Call Station Web GUI Application

Unable to access the VOIP Call Station Web GUI Application

Unable to access the VOIP Call Station Web GUI Application

Possible Resolutions:
  1. The IP address being used in the Web browser is incorrect. Connect the serial console and check the phone’s IP address via the ‘ifconfig’ command.
  2. IP address of the phone is conflicting with another network device. Reassign a new IP address to the phone.
  3. The phone’s Web server is not responding. Reboot the phone.

If you need additional assistance, please email us at support@talkaphone.com or call 773-539-1100 and select Technical Support.
    • Related Articles

    • VOIP-500 and VOIP-600 Installation Guide

      Call Station Installation Guide for Model VOIP-500 and Model VOIP-600 To jump to the INSTALLATION Steps, use the Table of Contents links. Overview and Intended Audience This guide provides detailed instructions for the configuration and operation of ...
    • BASIC Programming of Analog (ETP) Call Stations

      What is the BASIC programming codes for the analog (ETP) devices? Resolution: What you will need: Analog telephone or test-set to dial in access to the ETP device The BASIC of QUICK programming for analog ETP devices is as follows: Default ...
    • How To Install the AVM-1 (GXV3275) and the VOIP-500 or VOIP-600 (with IP Camera) - Peer To Peer

      This knowledge article describes the setup of the AVM-1 and the VOIP-500 or VOIP-600 (With IP Camera) in a peer-to-peer environment: Assumptions:  Technician has fundamental knowledge in computer networking and Voice over Internet Protocol (VoIP) ...
    • How To Install the AVM-1 (GXV3370) and the VOIP-500 or VOIP-600 (with IP Camera) - Peer To Peer

      This knowledge article describes the setup of the AVM-1 (GXV3370) and the VOIP-500 or VOIP-600 (With IP Camera) in a peer-to-peer environment: Assumptions: Technician has fundamental knowledge in computer networking and Voice over Internet Protocol ...
    • My ETP Call Station does not hang up.

      My ETP Call Station does not hang up. Possible Resolutions: The phone is on a PBX but is not programmed properly (see PBX/Timing Configuration Codes, p.9). Your phone is on a PBX that doesn't provide a) a hang-up pulse and b) produces a re-order tone ...