When attampting to program an ETP-100, ETP-100, ETP-400 or ETP-500 series device I receive 1 confirmation beep after the first * is entered.

• Related Articles

• Quick programming for the ETP-520 Series call stations

  NOTE: After each programming code, a single beep indicates the code has been accepted. A double-beep indicates an error—re-enter the code again. 1.1. Quick Programming Guide Programming the ETP-520 Series Call Station is relatively quick and easy. ...

• BASIC Programming of Analog (ETP) Call Stations

  What is the BASIC programming codes for the analog (ETP) devices? Resolution: What you will need: Analog telephone or test-set to dial in access to the ETP device The BASIC of QUICK programming for analog ETP devices is as follows: Default ...

• Unable to program an ETP-400, ETP-500, or ETP-520 when connected to an ETP-CI-4G-V or ETP-CI-4G-GSM

  Accessing configuration Configuration of the ETP-CI-4G-V or ETP-CI-4G-GSM is available via communications with the CONFIG USB connection. Configuration can be accomplished by connecting a terminal device (e.g. laptop or desktop computer running a ...

• How to change the Primary phone number on an ETP-400, ETP-500, ETP-100, ETP-103, or ETP-110

  You will need to know the number associated with the telephone line that the Talkaphone is connected to, and the number that the Talkaphone should call when the button is pressed. This also assume that there is not another device on the line that is ...

• Programming ETP Series Phones using the local phone on a EC-8 Consolidator

  What is the BASIC programming codes for the analog (ETP) devices by using the local phone on a EC-* Consolidator? Resolution: What you will need: Analog telephone or test-set to dial in access to the ETP device When using an EC-8, connect the local ...