When call is placed with ETP-500 there is a feedback screech at the callbox

When call is placed with ETP-500 there is a feedback screech at the callbox, or the speaker or microphone needs to be adjusted

Adjust the speaker and microphone gain down slightly to eliminate the feedback


    • Related Articles

    • Adjusting the Microphone/Speaker on the ETP-110 Series Analog Call Station

      How do I adjust the microphone/speaker balance for the ETP-110 Series Analog Call Station? Answer: 1. Remove the ETP-110 Series Analog Call Station from it from its mounting enclosure. 2. Remove the four (4) Phillips screws marked in red below. 3. ...

    • ETP-WM Series ADA Mounting Height Recomendations

      I. ADA Height Requirements In order for a call station to comply with the Americans With Disabilities Act (ADA), all operable parts (i.e. pushbuttons and keypad) must be no higher than 48.00” above the finished floor from a forward reach or 54.00” ...

    • Configuration for DataRemote CDS-9070 and ETP-500 Series Analog Call Stations

      Configuration for DataRemote\MetTel CDS-9070 and ETP-500 Series Analog Call Stations Configuration Required on the DataRemote\MetTel CDS-9070 CPC: Enabled CPC Delay: 10 seconds CPC Duration: 1 second Programming the ETP-500 series device Call into ...

    • AOR-IP-CSE Revision 1 Call station Configuration

      This article assumes that the suggested default IP scheme for the AOR-IP series is being used. The IP scheme can be found here . This article is for the first version of the AOR-IP-CSE That is based on the PCB with P/N 68820, It has two network ports ...

    • How do I change the Primary Number on an ETP-400

      Call the phone number for the line that the ETP-400 is attached to. Wait for the string of tones that is played when the ETP-400 answers the call. Enter *4** on the keypad of the phone you are calling from, and wait for a single tone in confirmation. ...