Technical Support
Recommended Programming for Viking K-1900-5
Problem: ETP series call stations are unable to dial out on non-traditional analog lines. (Cable modem terminal adapters, fiber module analog terminal adapters, etc. RESOLUTION: Install Viking Electronics K-1900-5 Auto Tone dialer. To program the ...
Talkaphone VOIP-500/VOIP-600 Integration with E2Campus Mass Notification platform
Here are the integration steps for e2campus and Talkaphone. e2campus recently upgraded their interface. I've included both sets of instructions below. Please don't hesitate to give me a call if you have any questions. e2campus (older interface) ...
ETP-EL Blue Light flashes when not in a call
Issue: ETP-EL Blue Light flashes when not in a call Environment: ETP Towers that have a Blue Light on/in them. Resolution: Disconnect the ORANGE/BLACK from the call station, if flashing stops, possible issue with the call station. If the flashing ...
Front status (CALLING and ANSWERED) LED's on VOIP Call Station Flashing
If the front LED's are continuously flashing on a VOIP-500/600 it means the device cannot register to a SIP server, firmware upgrade is in progress OR the device is in a constant reboot cycle due to not being able to obtain a DHCP IP address. ...
Off-Hook Voltage for ETP Modules
OFF hook voltage should be the following for ETP units: Technical Requirements Dedicated* P.O.T.S. type phone company line or Analog PBX line—you must know if your phone is on a PBX before you begin programming. If connected to a PBX, your extension ...
Default IP Addresses for Talkaphone Products
The default (Factory) IP Addresses are listed below for the various Talkaphone products: Resolution: VOIP-20X, VOIP-500/600: IP 192.168.1.10 SUBNET MASK 255.255.255.0 VOIP-22X, IP 192.168.1.10 SUBNET MASK 255.255.255.0 AVM-1 (Grandstream GXV3275) IP ...
Popular Articles
Programming the AOR series, and Analog stations for Day/Night Mode
Programming for an EC-8 or AOR Call into the unit or go off hook on the local phone, be sure and select the correct bank if working with an AOR-16, AOR-14, or AOR-32, and what for three tones. Enter *31** to access programming, wait for a single ...
BASIC Programming of Analog (ETP) Call Stations
What is the BASIC programming codes for the analog (ETP) devices? Resolution: What you will need: Analog telephone or test-set to dial in access to the ETP device The BASIC of QUICK programming for analog ETP devices is as follows: Default ...
What is the SIM Card Size for ETP-GSM (AT&T)
What type of SIM card does the ETP-GSM use for AT&T? ETP-GSM Answer: ETP-GSM uses the STANDARD SIM Card. SIM Card Sizes If you need additional assistance, please email us at support@talkaphone.com or call 773-539-1100 and select Technical Support.
Front status (CALLING and ANSWERED) LED's on VOIP Call Station Flashing
If the front LED's are continuously flashing on a VOIP-500/600 it means the device cannot register to a SIP server, firmware upgrade is in progress OR the device is in a constant reboot cycle due to not being able to obtain a DHCP IP address. ...
ETP-EL Blue Light flashes when not in a call
Issue: ETP-EL Blue Light flashes when not in a call Environment: ETP Towers that have a Blue Light on/in them. Resolution: Disconnect the ORANGE/BLACK from the call station, if flashing stops, possible issue with the call station. If the flashing ...