My AOR is sounding alarms after I have connected the Call Stations, how do I fix?

My AOR is sounding alarms after I have connected the Call Stations, how do I fix?

My AOR is sounding alarms after I have connected the Call Stations, how do I fix?

Answer:

Typically, this is because you have less than the total connections physically connected to the AOR and the dial next to the connections is not set properly.

After dial is set to appropriate number to match number of Call Stations, Press the RESET button TWICE.
    1. First press Silences the alarms
    2. Second press of reset button RETESTS the Call Station ports
For example, if you have an AOR-8 and you only have 5 Call Stations, the dial needs to be set to 5 to ensure the AOR will operate properly. The dial is at the bottom of the PCBA for the Call Station connectors. (See image below):
AOR Call Station Connections with Dial

If you need additional assistance, please email us at support@talkaphone.com or call 773-539-1100 and select Technical Support.

    • Related Articles

    • Area of Rescue Command Unit Installation Guide for Model AOR-8 and Model AOR-16

      Important Notice THIS PRODUCT MUST BE INSTALLED IN ACCORDANCE WITH THE APPLICABLE INSTALLATION CODE BY A PERSON FAMILIAR WITH THE CONSTRUCTION AND OPERATION OF THE PRODUCT AND THE HAZARDS INVOLVED CE PRODUIT DOIT ÊTRE INSTALLÉ SELON LE CODE ...

    • Troubleshooting AOR Series Trouble Lights

      PURPOSE The purpose of this document is to explain the various reasons for trouble status Lights on the AOR series Command Unit. This includes the AOR-8, AOR-16, AOR-24, and AOR-32. The AOR command units will test the circuit integrity from the main ...

    • Unable Make Outside Call on AOR-5 or AOR-10 Series System.

      1. Is the outside line status light turning on? No: Does the line have working Dial tone? If yes proceed to the next step. If no , then address issue with the phone line first. A. Check to make sure the phone line is connected to the PSTN terminals. ...

    • Programming the AOR series, and Analog stations for Day/Night Mode

      Programming for an EC-8 or AOR   Call into the unit or go off hook on the local phone, be sure and select the correct bank if working with an AOR-16, AOR-14, or AOR-32, and what for three tones. Enter *31** to access programming,  wait for a single ...

    • Configur AOR-IP-CSE Revision 2

      Download the configuration app and update from this article: AOR-IP-CSE Appilictaion download (Non Web Interface Version) 1. Launch the Talkaphone Programming software. 2. Select the device you wish to program. 3. Click the Connect button. 4. If you ...