PS-15 solar controller DIP switch settings.

• Related Articles

• Serial Connection Settings for the DB9 Console Port on VOIP-500-600 Call Stations

  Serial Connection Settings for the DB9 Console Port on VOIP-500-600 Call Stations Resolution: The DB9 Connection is a FEMALE connection requiring a straight-through serial cable with a MALE connection for the Call Station side. The settings are: Baud ...

• What are the SERIAL settings for the VOIP-500 and VOIP-600 for console connectivity?

  What are the SERIAL settings for the VOIP-500 and VOIP-600 for console connectivity? Answer: Using your favorite console/terminal software, configure your serial settings to the following: Speed (baud rate): 115200 Data Bits: 8 Stop bits: 1 Parity: ...

• I have made several mistakes in programming my ETP Call Station and/or I don't know what has been programmed into my phone. Can I start over from the factory settings?

  I have made several mistakes in programming my ETP Call Station and/or I don't know what has been programmed into my phone. Can I start over from the factory settings? Answer: There is no programming code that resets you phone to factory settings. ...

• How to find out the IP Address acquired by the VOIP-500/VOIP-600 IP Call Stations from the DHCP server using Serial connection?

  Requirements: Serial connection to the VOIP-500 or VOIP-600 FTP server that supports receiving files via ftpput.  Filezilla will support this Power supply or POE switch Network connection to VOIP-500 or VOIP-600. Procedure: 1.  Connect a ...

• Unable Make Outside Call on AOR-5 or AOR-10 Series System.

  1. Is the outside line status light turning on? No: Does the line have working Dial tone? If yes proceed to the next step. If no , then address issue with the phone line first. A. Check to make sure the phone line is connected to the PSTN terminals. ...