ADA Compliance & Call Stations

ADA Compliance & Call Stations

Introduction

When planning the design of a system for emergency communication, area of refuge (rescue assistance), or other similar needs, the question of mounting locations, heights, etc. often comes to mind.  Please refer to the below resources as they pertain to such questions on ADA compliance.

Reach Range

In general, the maximum reach range for an operable part of the call station is 48-inches.

Please consult the below resources and/or a locally licensed ADA compliance subject matter expert for further guidance.

2010 ADA Standards for Accessible Design


Here are some critical highlights as they relate to Talkaphone's products:
Section 205 - Operable Parts

Section 308 - Reach Ranges

407.4.9 Emergency Communication. Emergency two-way communication systems shall comply with 308. Tactile symbols and characters shall be provided adjacent to the device and shall comply with 703.2.

Section 708 - Two-Way Communication Systems
The United States Access Board (www.access-board.gov) also provides an illustrated guide to the ADA standards.  Chapter (3) - Operable Parts is recommended as a starting point:


    • Related Articles

    • VOIP-500 and VOIP-600 Installation Guide

      Call Station Installation Guide for Model VOIP-500 and Model VOIP-600 To jump to the INSTALLATION Steps, use the Table of Contents links. Overview and Intended Audience This guide provides detailed instructions for the configuration and operation of ...

    • How to do a packet capture on the VOIP-500/VOIP-600 Series IP Call Stations using tcpdump?

      1.    Login to the VOIP-500/VOIP-600 Call Station console either by using a Serial cable or through SSH. 2.    Navigate to the /flash directory- root:/> cd /flash 3.    Run the command to start capturing packets- root:/flash> tcpdump -w call1.pcap ...

    • BASIC Programming of Analog (ETP) Call Stations

      What is the BASIC programming codes for the analog (ETP) devices? Resolution: What you will need: Analog telephone or test-set to dial in access to the ETP device The BASIC of QUICK programming for analog ETP devices is as follows: Default ...

    • Serial Connection Settings for the DB9 Console Port on VOIP-500-600 Call Stations

      Serial Connection Settings for the DB9 Console Port on VOIP-500-600 Call Stations Resolution: The DB9 Connection is a FEMALE connection requiring a straight-through serial cable with a MALE connection for the Call Station side. The settings are: Baud ...

    • Quick programming for the ETP-520 Series call stations

      NOTE: After each programming code, a single beep indicates the code has been accepted. A double-beep indicates an error—re-enter the code again. 1.1. Quick Programming Guide Programming the ETP-520 Series Call Station is relatively quick and easy. ...